D-Link DCS-1000 Manual page 25

SMTP (Simple Mail Transfer Protocol) is a protocol for sending e-
mail messages between servers you need to input the mail server
address in this field.
Sender e-mail is the person's e -mail address whom will be sending
the e-mail.
Receiver e-mail is the e-mail address of the person whom will receive
the e-mail.
Sending Interval is the period of time between each e-mail being sent
to the receiver. If the setting is at 10 seconds, a new e -mail will be
sent in 10 seconds interval to the receiver.
Sending Time is the number of times the e-mail will be sent to the
receiver before it terminates.
Select "Trigger I/O Output" and enter the setting for the duration of the
output device for Output 1 time and Output 2 time in seconds.
I/O Input 2 Trigger:
Select "Send e-mail attached with image" and enter the relevant information
such as the SMPT Server Address, Sender e-mail Address, Receiver e-mail
Address, Sending Interval and Sending Times.
SMTP (Simple Mail Transfer Protocol) is a protocol for sending e-
mail messages between servers you need to input the mail server
address in this field.
Sender e-mail is the person's e -mail address whom will be sending
the e-mail.
Receiver e-mail is the e-mail address of the person whom will receive
the e-mail.
Sending Interval is the period of time between each e-mail being sent
to the receiver. If the setting is at 10 seconds, a new e -mail will be
sent in 10 seconds interval to the receiver.
Sending Time is the number of times the e-mail will be sent to the
receiver before it terminates.
Select "Trigger I/O Output" and enter the setting for the duration of the
output device for Output 1 time and Output 2 time in seconds.
Save/Cancel:
After making sure all settings in the System are correct, click on the "Save"
icon to store the settings for the DCS-1000. You can alternatively click on the
24