Select Watch Points (Cmd 63) - Bosch D621 User Manual

Select Watch Points (Cmd 63)

The Watch feature gives you the ability to "watch" points when the system is off.
For example, parents with small children may want a tone to sound whenever a
door or window is opened as a way of monitoring the location of the children.
Once you have decided how your system responds to watched points (see Select
Watch Tone), you need to decide which of the points in your system will be
watched. Use this command to tell your system which points to watch. You cannot
watch 24-hr. or fire points.
Choosing which points to watch depends upon your goals. If you have small
children, you may choose to watch points of entry and exit. Each time a watch
point is faulted (a door or window is opened), the Command Center responds as
programmed. For example, you may tell your system to produce a short beep
when a watch point is faulted.
1. Make sure your system is off (All and Part indicators are off).
2. Press [CMD] [6] [3]. The Command Center may prompt you to
enter a valid passcode by flashing the Cmd indicator.
3. Enter your passcode if necessary. The Command Center displays all
points that are currently being watched (Watch On).
• Point Indicator On Solid: indicates point(s) already being
"watched."
• Point Indicator Flashing: indicates point(s) available to be
"watched."
4. Enter the point number you want to watch followed by the [*] key.
(For example, press [5] [*] to watch Point 5.) Repeat this step to
select all the points you want to watch. To turn Watch Mode off for a
point, enter the point number followed by the [*] key. (For example,
press [5] [*] to turn Watch off for Point 5.)
1 2 3 4
9 10 11 12 13 14 15 16
5. Press [CMD] to exit this command.
© 2003 Bosch Security Systems
D621 User's Guide
I can perform this command.
I cannot perform this command.
5 6 7 8
D621 User's Guide
Page 39
Status
All
Part Cmd
46840D