Removing The Battery - Epson P-2500 User Manual

Proof Sign-off:
YIT N.Yoshida, A.Seki
T.Takahashi
YIT J.Scarborough
2. Connect the AC adapter as shown below, then
plug the other end into a power outlet.
The Charge lamp will glow during charging. When
the battery is fully charged, the Charge lamp turns
off. It takes about 3.5 hours to fully charge the battery
when the power is off, more time if the device is in
use.
Note:
This device stops charging if the battery becomes hot when
operating it during charging. In that case, it starts
charging again when it cools down.

Removing the battery

1. Make sure that this device is turned off.
R4CG710
User's Guide
GET.FM
2/1/06
Caution:
c
❏
Remove the AC adapter if connected.
❏
Never remove the battery while turned on.
Charge lamp
Doing so may cause data in the card or
HDD to be lost or damaged.
2. Open the battery cover.
3. Push the catch down.
The battery is pushed out.
Rev. E
A5 size
2
2
2
2
2
2
2
2
2
2
9
Getting Started
R