Electrolux EN18WI30LS Use And Care Manual page 22

Preventing Damage from Freezing-3
For EN19WI30LS, EP19WI30LS
If the water heater will not be used for a long period of time, drain the water.
Drain the water as follows:
CAUTION
Drain water into a bucket to prevent water damage.
Drainage Using the Remote Controller
1
(2) Press the flow meter alarm set
button for about two seconds
until the alarm sounds.
The maximum hot water
temperature will flash.
(3) Press the flow meter alarm
set button again.
(4) Press the setting button
the button is pushed.
2
Close the water supply
valve.
3
Fully open all hot water fixtures.
4
Open all drain plugs and drain the water out of
the unit.
5
When the water is completely drained, replace
all drain plugs and close the hot water fixtures.
6
Close the gas valve and disconnect
the electrical power supplied to the unit.
Do not touch with wet hands.
20
High Temperature
(Ex. 120°F)
. The display will
Fixture
To avoid burns, wait until the equipment cools down
before draining the water. The appliance will remain
hot after it is turned off.
1
Close the gas valve.
2
(2) Turn and leave open
the hot water fixtures
for more than 2 minutes
and close.
* An 11 Error Code may appear on
3
Close the water supply
valve and disconnect
the electrical power
supplied to the unit.
Do not touch with wet hands.
4
Fully open all
hot water fixtures.
5
Open all drain plugs and drain the
water out of the unit.
6
W h e n t h e w a t e r i s c o m p l e t e l y
drained, replace all drain plugs and
close the hot water fixtures.
Drain Plugs
Each drain plug might not be visible if
insulation is installed around the piping.
Manual Draining
Fixture
* If multiple units are being used,
drain two minutes for each unit.
the remote controller.
This is not a malfunction of the unit.
Fixture