Signal Menu - Panasonic TH-50PB2W Operating Instructions Manual

Signal menu

Notes:
• "Signal" setup menu displays a different setting condition for each input signal.
• Depending on the input signal type, an optional Terminal Board may be required.
Select "Signal" in "Setup" menu and press
For Video (S VIDEO)
[ AV ]
Signal
3D Y/C Filter (NTSC) On
Auto
Colour system
Cinema reality Off
Noise reduction Off
For Component
[ Component ]
Signal
Sync Auto
Cinema reality Off
XGA Mode Auto
Noise reduction Off
H-Freq. 63.98 kHz
V-Freq. 60.02 Hz
Signal Format 1280×1024/60i
• 3D Y/C Filter (NTSC)
This menu is displayed when BNC Dual Video Terminal Board (TY-FB9BD) is installed to the unit.
Set this menu when the moving image looks unnatural during Video (S Video) input signal.
On Off
Note:
When On, this setting only affects NTSC input signals.
• Colour system
Auto PAL
Set the colour system to match the input signal. When "Auto" is set, Colour system will be automatically selected
from NTSC/PAL/SECAM/M.NTSC.
To display PAL60 signal, select "Auto" or "PAL".
If the picture image becomes unstable:
With the system set on Auto, under conditions of low level or noisy input signals the image may in rare cases
become unstable. Should this occur, set the system to match the format of the input signal.
• Cinema reality
When "On", the display attempts to reproduce a more natural interpretation of sources such as movie pictures,
which are recorded at 24 frames per second.
If the picture is not stable, turn the setting to "Off".
On Off
Note:
When On, this setting only affects the following signal input:
• NTSC / PAL signal input during Video (S Video) input signal.
• 525i(480i), 625i(575i), 1125(1080)/60i signal input during "Component" input signal.
• XGA Mode
This menu is displayed when the input signal is analog (Component/PC). This unit supports three types of XGA
signals with 60Hz vertical frequency having different aspect ratios and sampling rates (1,024 × 768 @ 60Hz,
1,280 × 768 @ 60Hz and 1,366 × 768 @ 60Hz).
Auto 1024×768
Auto: Automatically selected from 1024×768/1280×768/1366×768.
Switch the setting to suit the input signal for better display depends on the angle of view or display
resolution condition.
Note:
After making this setting, be sure to make each adjustment (such as "Auto Setup") on the "Pos./Size" menu as
necessary. (see page 23)
button.
For RGB
[ RGB ]
Signal
Sync Auto
Cinema reality Off
XGA Mode Auto
Noise reduction Off
H-Freq. 63.98 kHz
V-Freq. 60.02 Hz
Signal Format 1280×1024/60i
For Digital
[ Digital ]
Signal
Cinema reality Off
HDMI Range Auto
Noise reduction Off
H-Freq. 63.98 kHz
V-Freq. 60.02 Hz
Signal Format 1280×1024/60i
SECAM M.NTSC
1280×768 1366×768
Setup for Input Signals
NTSC
47