Using The Driver Utility Software - Pioneer DDJ-WeGO2 Operating Instructions Manual

10 Click [Finish].
This completes the installation procedure.
VIRTUAL DJ LE is launched if [Launch VirtualDJ] on the screen is
checked when [Finish] is clicked.
11 Input the serial number printed on this unit's bottom
panel (XXXX-XXXX-XXXXX/WEGO2), then click [OK].
This unit' s bottom panel
 Connecting this unit and computer
1 Connect this unit to your computer via a USB cable.
For instructions on connections, see Connecting with a computer on
page 8.
2 Slide this unit's [ON/OFF] switch to the [ON] position.
Turn on the power of this unit.
! The message [Installing device driver software] may appear when
this unit is first connected to the computer or when it is connected to
a different USB port on the computer. Wait a while until the message
[Your devices are ready for use] appears.
About the installation procedure (Mac OS X)
1 Insert the included CD-ROM into the computer's CD
drive.
The [CD_menu] icon appears on the screen. Double-click it.
2 When the CD-ROM's menu is displayed, select [Install
VIRTUAL DJ LE(DDJ-WeGO2)], then click [Start].
The VIRTUAL DJ LE installer is launched.
3 Once the VIRTUAL DJ LE installer is launched, click
[Continue].
4 Read the contents of the license agreement carefully,
click [Continue] and then click [Agree] to accept the
license agreement.
If you do not agree to the license agreement, click [Disagree] to cancel
installation.
6
En
VIRTUAL DJ LE Serial number
5 Select the type of installation for VIRTUAL DJ LE, then
click [Install].
— To select standard installation, click [Install].
— To install in a different location, click [Change Install
Location...] and choose the place of installation.
Installation begins.
The message of successful installation appears once installation is
completed.
6 Click [Close].
This completes the installation procedure.

Using the driver utility software

This unit functions as an audio device conforming to the ASIO
standards.
Using the settings utility software
This function can only be used by those using a Windows operating
system.
 Launching the settings utility software
Click the Windows [Start] menu>[All Programs]>
[Pioneer]>[DDJ_WeGO2]>[DDJ_WeGO2 ASIO Settings
Utility].
! For Windows 8, click [DDJ_WeGO2 ASIO Settings Utility] from the
[Start] screen.
 Adjusting the buffer size
This unit functions as an audio device conforming to the ASIO
standards.
! If an application using this unit as the default audio device (DJ
software, etc.) is running, quit that application before adjusting the
buffer size.
! If the buffer size is made large, drops in audio data (breaks in the
sound) occur less easily, but the time lag due to the delay in the
transfer of the audio data (latency) increases.
! If the kernel buffer number is made large, breaks in the sound occur
less easily, but the time lag due to latency increases.
! Operate referring to the procedure below to adjust the buffer size and
kernel buffer.