Brother DCP-J925DW Basic User's Manual page 54

Error Message
Cannot Detect
Cannot Print
Replace Ink
Check for a Printable
Disc
Cover is Open.
Data Remaining
Disc Jam [Front]
Disc Jam [Rear]
Disc Tray did not
Feed
46
Cause
You installed a new ink cartridge too
quickly and the machine did not detect
it.
If you are using non Brother Original
ink the machine may not detect the ink
cartridge.
An ink cartridge is not installed
correctly.
One or more of the ink cartridges have
reached the end of their life. The
machine will stop all print operations.
The disc cannot be printed on.
There is no disc in the Disc Tray.
The scanner cover is not completely
closed.
The ink cartridge cover is not
completely closed.
Print data is left in the machine's
memory.
The disc jammed while printing. The
Disc Tray was automatically ejected
from the front of the machine.
The disc jammed while printing.
The Disc Tray is not inserted into the
Disc Guide.
Action
Take out the new ink cartridge and
re-install it slowly until it clicks.
Replace the cartridge with a Brother
Original ink cartridge. If the error
message remains, contact your
Brother dealer.
Take out the new ink cartridge and
re-install it slowly until it clicks. (See
Replacing the ink cartridges
uu page 39.)
Replace the ink cartridges. (See
Replacing the ink cartridges
uu page 39.)
Remove the disc and place a printable
disc on the Disc Tray. Insert the Disc
Tray into the Disc Guide and line up
the triangular marks.
Press Start.
Make sure a disc is correctly placed in
the Disc Tray.
Lift the scanner cover and then close it
again.
Firmly close the ink cartridge cover
until it clicks.
Press Stop/Exit. The machine will
cancel the job and clear it from the
memory. Try to print again.
Remove the Disc Tray from the Disc
Guide.
(See Disc Tray is jammed at the front
of the machine uu page 58.)
Make sure there is enough space
behind the machine.
Lift the scanner cover. Gently push the
Disc Tray toward the back of the
machine and remove the Disc Tray.
(See Disc Tray is jammed at the back
of the machine uu page 59.)
After placing a disc on the Disc Tray,
insert the Disc Tray into the Disc
Guide and line up the triangular
marks. Press Start.