Table of Contents
Advertisement
Programming
Programming
The following procedures describe the programming
required for Caller ID setup. In addition, these
procedures can also be used to reconfigure the
Caller ID feature once it is operational.
Note: In the following programming procedures,
default settings appear in bold.
General Caller ID Setup
1. Assign the appropriate loop-start trunks as Caller
ID trunks.
Program
Trunk Type
Name
Address
FF2 (1-64)# 21# (0-4)#
Options
0=Loop start
1=Ground start
2=DID
3=T1
4=Caller ID
Note: The DBS must be powered off and on for this
program to take effect.
Flexible Display of Caller ID Information
1. Determine if the Call Duration Display will be used.
If used, the Call Duration Time will replace the
Caller ID information on the display after a
specified time. The specified time is
2-4
Issued April 2000
Hide quick links:
Advertisement
Table of Contents
