Installing The Low Profile Expansion Card Divider Unit - Dell PowerEdge VRTX Owner's Manual

9. Holding it by its sides, lift the divider unit up and away from the chassis.
Figure 60. Removing and Installing the Low Profile Expansion Card Divider Unit
1. expansion-card divider
3. guide pin

Installing The Low Profile Expansion Card Divider Unit

CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1. Align the expansion-card divider unit with the guide pin on the system board.
2. Lower the divider unit into the chassis.
When properly seated, the screw holes on the divider unit align with the screw holes on the chassis.
3. Install the screws to secure the divider unit to the chassis.
4. If applicable, reinstall the expansion cards.
5. Close the system.
6. If applicable, place the system upright on a flat, stable surface and rotate the system feet outward.
7. If removed, reinstall the hard drives, server modules, and power supplies.
8. Reconnect the enclosure to its electrical outlet and turn the enclosure on, including any attached peripherals.
9. Turn on the server modules using the operating system commands or the CMC.
10. If applicable, install the front bezel.
2. screws (5)
4. expansion-card connectors on system board
(5)
91