Scanning Sequence Examples; Errors While Scanning; User Preferences/Miscellaneous Option Parameter Defaults - Motorola LI4278 Product Reference Manual

5 - 2 LI4278 Product Reference Guide

Scanning Sequence Examples

In most cases scanning one bar code sets the parameter value. For example, to set the beeper tone to high,
scan the High Frequency (beeper tone) bar code listed under
scanner issues a fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters require scanning several bar codes. See these parameter descriptions for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

User Preferences/Miscellaneous Option Parameter Defaults

Table 5-1 lists the defaults for preferences parameters. To change the default values:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the
•
Configure the linear imager scanner using the 123Scan
10-1).
NOTE See
miscellaneous default parameters.
User Preferences Parameter Defaults
Table 5-1
Parameter
User Preferences
Set Default Parameter
Report Version
Parameter Bar Code Scanning
Beep After Good Decode
Decode Illumination Indicator
Suppress Power Up Beeps
Beeper Tone
Beeper Volume
Beeper Duration
Hand-Held Trigger Mode
Hands-Free Mode
Low Power Mode
Time Delay to Low Power Mode
Appendix A, STANDARD DEFAULT PARAMETERS
Parameter
Number
N/A
ECh
38h
F2h 5Bh
F1h D1h
91h
8Ch
F1h 74h
8Ah
F1h 76h
80h
92h
Beeper Tone on page
Default Parameters on page
2
configuration program (see
for all user preferences, hosts, symbologies, and
Default
Restore Defaults
N/A
Enable
Enable
Disable
Do Not Suppress (Disable)
Medium
High
Medium
Level
Enable
Enabled
100 msec
5-7. The linear imager
5-4.
123SCAN2 on page
Page
Number
5-4
5-5
5-5
5-6
5-6
5-6
5-7
5-8
5-9
5-10
5-11
5-12
5-13