Aligning Control Panel With Drawer Fronts; Installing The Custom Door Panel - Miele Dishwasher Operating Instructions Manual

4. Aligning the control panel
with the drawer fronts.
The control panel can be aligned
with the drawer fronts of the kitchen
cabinets by adjusting the spacer
bars.
Using an 8 mm socket, turn the nut
clockwise or counterclockwise until
the spacers reach the required
height.
If necessary, individual (or all)
spacer bars can be removed.
Adjustment range:
from 4 1/2" (112 mm) (control panel
without spacer bars)
to 5 3/4" (145 mm) (control panel with
four spacer bars).
In special circumstances a fifth spacer
bar (optional accessory) can be used to
increase the panel height to 6" (154 mm).
After adjusting the control panel
height, cut off the plastic screw ex-
cess.
Dishwasher installation
5. Installing the custom
door panel.
A custom door panel matching the kit-
chen cabinetry can be installed on the
dishwasher by using the provided
bracket.
Length: 21" - 25 3/4" (53.3 - 65.4 cm)
Width: 23 1/2" (59.8 cm)
Note: The maximum panel length is
only applicable when no spacer bars
are used.
If a Stainless Steel panel is being used,
please follow the separate installation
instructions included with the panel.
After panel installation, see Step 6 "Ad-
justing the door springs".
Proceed as follows:
Measure the distance (X) between
the lower mounting hole on the dish-
washer front door (see inset arrow)
and the lower edge of the neighbor-
ing cabinet door.
47