Brake Pedal; Park Brake - Husqvarna HUV 4213-GXP Owner's Manual

Controls and Indicators

BRAKE PEDAL

The brake pedal is the large pedal on the left with the word STOP molded into it (Figure 5). To slow or stop
the vehicle, press the brake pedal (Figure 6).
Figure 5 Accelerator and Brake Pedal Figure 6 Brake Pedal

PARK BRAKE

The park brake handle is located between the driver and passenger seats. To engage the park brake, first
apply pressure to the brake pedal, and then pull up on the park brake handle until handle latches into place.
To disengage, pull up on the handle and press the button on the end of the handle. Push handle down. See
following WARNING.
ý
WARNING
• The park brake has multiple locking positions and should be firmly locked to prevent the
vehicle from rolling.
CHOKE
The choke is located on the seat support panel below and to the left of the driver's left knee. If the vehicle is
hard to start in cool or cold temperatures, activate choke: Pull the choke handle out to activate. Release the
handle when the engine begins to run smoothly (Figure 7).
Figure 7 Choke Figure 8 Differential Lock
Page 14 2007 HUV4213 Gasoline Vehicle Owner's Manual