Table of Contents
Advertisement
ý
WARNING
• Do not jump-start a dead battery using another battery and jumper cables.
The battery in a Husqvarna vehicle is a 12-volt, low-maintenance battery that requires infrequent checks
(Figure 25). Electrolyte level should be checked semiannually.
1. Turn the key switch to the OFF position and remove the key. Place the Forward/Reverse handle in the
NEUTRAL position. Chock the wheels.
2. Access the engine compartment. See WARNING "For vehicles with cargo beds..." on page 10.
3. Tilt the bed and ensure that the prop rod is properly engaged.
4. Disconnect the battery cables, negative (–) cable first. See WARNING "To avoid unintentionally start-
ing..." on page 10.
5. Use a flat blade screwdriver, and carefully remove the battery cell caps from the battery (Figure 25). See
following WARNING.
ý
WARNING
• Wear safety glasses or approved eye protection when servicing the vehicle. Wear a full face
shield and rubber gloves when working on or near batteries.
6. Carefully check the electrolyte level and add distilled water if necessary. Do not fill above designated fill
line. Replace battery cell caps.
Figure 25 Battery
7. Clean both battery terminals with a solution of baking soda and water (1 cup (237 mL) baking soda per
1 gallon (3.8 L) of water). Rinse thoroughly. Do not allow this solution to enter the battery. Tighten battery
terminals to 12 ft-lb (16 N·m). Let the terminals dry and then spray them with Battery Terminal Protector
Spray (P/N 603 00 00-03). See following WARNING.
ý
WARNING
• If battery wire terminals are damaged or corroded, replace or clean them as necessary. Failure
to do so may cause them to overheat during operation and could result in fire, property
damage, or personal injury.
LEVEL
INDICATOR
Figure 26 Battery Electrolyte Level
2007 HUV4213 Gasoline Vehicle Owner's Manual
Battery
BATTERY
CAP
PLATES
ELECTROLYTE
LEVEL AT LEAST
1/2-INCH (13 MM)
ABOVE
PLATES OR
TO LEVEL
INDICATOR
Page 35
Advertisement
Table of Contents
