Pioneer SGX-CA500 User Manual page 51

Sensor Calibration
A calibration menu is also displayed in sensor information when the sensor device type is [Pedaling Monitor L], [Pedaling
Monitor R], or [Power].
When the device type is [Pedaling Monitor L] or [Pedaling Monitor R]
The items shown below are displayed in sensor information.
Setting Item
Force Preview Tangential Direction
Force
Radial Direction Force Shows the radial load.
Calibration (Zero) Start Calibration
Status
Result
Data (Tangential)
Data (Radial)
Error Code
• For information about how to calibrate the Pedaling Monitor Sensor series SGY-PM910H/PM900H, refer to the Installation Manual or the
User's Manual that comes with the Pedaling Monitor Sensor series SGY-PM910H/PM900H.
When the device type is [Power]
The items shown below are displayed in sensor information.
Setting Item
Calibration Start Calibration
Status
Result
Data
Auto Calibration
Torque
Shows the tangential load.
Tap to start calibration.
Shows the calibration status (Unknown, Processing..., Process done).
Shows the calibration result (Success, Failure).
Shows tangential data obtained from calibration.
Shows radial data obtained from calibration.
Displays the error code that indicates the cause when the sensor calibration is
failed.
Tap the button to start PowerMeter calibration.
Shows the calibration status.
Shows the calibration result (Success, Failure).
Shows data obtained from calibration.
Specify the auto calibration function when the Power Meter is compatible with
the auto calibration function.
Displays the torque value when the Power Meter is programmed to output the
torque value.
Description
Description
Sensor Settings
EN
51