Pioneer SGX-CA500 User Manual page 59

Cannot pair sensors with the device.
Cause
Multiple sensors are activated.
The battery of the sensor is almost empty.
Or the battery is not loaded in the sensor correctly.
The latitude and longitude are not displayed.
Cause
Reception is poor when inside a room or in areas surrounded
by mountains or tall buildings.
It may take a few minutes to display the latitude and longitude
when you use the device the first time.
The Cyclocomputer is not recognized when connected to a PC.
Cause
The Cyclocomputer is not connected correctly to the PC.
Response is different from the location touched on the touch panel.
Cause
The touch panel is not calibrated correctly.
GPS information is not received correctly.
Cause
Nearby tall buildings or trees are blocking communication.
Solution
Bring the device closer to the sensor you want to pair with or
specify the sensor device number and then try pairing.
Pairing Sensors (page 13)
Replace the battery with a new one.
Or check to make sure that the battery is correctly loaded in
the sensor.
For details about how to replace and load the sensor battery,
refer to the sensor user's manuals.
Solution
Use the device outside in an open area.
When you use the device for the first time, you may need to
allow extra time.
Solution
Unplug the USB cable from the device and PC and restart the
device. After that, try connecting to the PC with the USB cable
again.
Solution
Recalibrate the touch panel.
Calibrating the Touch Panel (page 47)
Solution
Move away from the tall buildings or trees, wait for a few
minutes, and try again.
Troubleshooting
EN
59