Brocade M5424 Fc8 I/O Module - Dell PowerEdge M1000E BMX01 Owner's Manual

Fibre channel port speed indicator
Module status
Indicator
indicator
Off
Green on
Amber on
Green/amber blinking Diagnostic message is in error log, or environmental range is
Module power indicator
Status/identification indicator

Brocade M5424 FC8 I/O Module

The Brocade M5424 FC8 I/O module includes eight external autosensing fibre channel ports (four ports are enabled in
the standard configuration and four additional ports may be enabled as an optional upgrade), 16 internal ports, and one
serial port with an RJ-45 connector. The external fibre channel ports operate at 8 Gb/sec, 4 Gb/sec, or 2 Gb/sec.
NOTE: CMC firmware version 1.3 is required to support FC8 mezzanine cards and I/O modules.
NOTE: This fibre channel switch module includes Short Wave SFP optical transceivers. To ensure proper
functionality, use only SFPs provided with this module.
Indicator
Off
Green on
Amber on
Status
Module is off or enclosure power is off
All ports are ready for use
Module is being reset, or ports are offline
exceeded
Indicator Status
Off Power to the module is off
Green Module has power
Indicator Status
Blue on Primary module in a stack, if applicable
Blue off Secondary module in a stack
Amber flashing Fault condition in module
Status
1 Gb link established
2 Gb link established
4 Gb link established
67