Fujitsu SCALEOVIEW S17-2 Operating Manual page 64

Maintaining Units
Press the printer head release trigger on the left side of the printer and remove the paper.
2
Note: In Encore S series units, the printer is installed in an inverted manner. Hence, the
Figure 5-27: Printer Head Release Trigger
Tear paper at the paper feed and at the paper chute.
3
Gently pull the paper through the module, until it is completely removed. Leave no shards in
4
the unit, especially in the printer chute.
Note: Rotate the gears to release the shards, if required.
Lower the module back on the paper bucket and push the right blue pin in place.
5
Figure 5-28: Printer Module - Removal of Shards
Page 60
printer head release trigger is on the right side of the printer.
MDE-3893P Encore® and Eclipse® Series Owner's Manual · December 2011
Periodic Maintenance Requirements
Printer Head
Release Trigger
Removing Paper Shards
from the Unit