Fujitsu SCALEOVIEW S17-2 Operating Manual page 45

Periodic Inspections
Recommended
Frequency
Every six months Pump pulleys,
Every six months Nozzle hooks
Every six months Door locks
Every 12 months
or as required in
harsh climate
MDE-3893P Encore® and Eclipse® Series Owner's Manual · December 2011
Components Recommended Maintenance
1. Remove power to the unit.
belts, and belt
tension
WARNING
To prevent an injury, remove power to the pump/dispenser
before you start the maintenance activity.
CAUTION
To avoid injury, avoid getting your fingers in a pinch point
between the pulley and belt during an inspection.
2. Inspect belts for fraying/cracks.
3. Inspect pulleys for excessive wear in grooves and
excessive bearing play.
4. Ensure that there is no more than one inch of play
on either side of the belt, by pressing the belt
midway between the two pulleys.
Note: If repair is required, call an ASC/CSC.
WARNING
Do not attempt to make these repairs yourself. Doing so could
result in severe injury or death.
1. Lubricate with silicone grease, if required.
and shafts 2. Check for damage.
3. Ensure that the locking tab locator is not broken.
The locking tab locator helps hold the nozzle in
the nozzle boot and enables the station owner to
lock the nozzle boot with a clasp padlock.
Note: If repair is required, call an ASC/CSC.
WARNING
Do not attempt to make these repairs yourself. Doing so could
result in severe injury or death.
Lubricate with a graphite lubricant or lock oil. Follow
manufacturer's instructions. Do not over-lubricate.
Polish unit
Polish metal parts with Nu Finish
use automobile wax. Refer to
and Component Maintenance Inspections"
page 32.
Maintaining Units
Who Performs the
Inspection/Repair
• Owner—Inspect
• ASC/CSC only—Repair
and test
CAUTION
CAUTION
CAUTION
• Owner—Inspect
• ASC/CSC only—Repair
and test
CAUTION
Owner
Owner
®
car polish. Do not
"Performing General
on
Page 41