Fitting The Cutting Unit - Husqvarna Rider Pro 15 Operator's Manual

Fitting the cutting unit

1. Place the Rider on a flat surface and apply the
parking brake. Check that the lever for setting the
cutting height is in the lowest position.
Make sure the support wheels are fitted to the
cutting unit (1).
2. Grasp the handle at the front (BioClip 90) or
hold the frame of the cutting unit (2) and slide
the unit underneath the rider mower, making
sure that the tongue on the cutting unit (3)
engages correctly. Picture, see page 33.
3. Insert the bolt and secure it with a locking pin.
WARNING!
Observe caution to avoid trapping
your hand.
4. Press down the frame and insert the pin. Fit the
drive belt around the drive wheels of the cutting
unit.
5. Hook up the height adjustment strut.
6. Fit the front cover.
7. Fit the spring that tensions the tensioning
pulley.
30
– English
MAINTENANCE
1
3
2
6017-159
6017-120
6017-160
6017-144