Installing The Hood - Frigidaire LI30MB Use & Care Manual

Hide thumbs Also See for LI30MB:

Manual de uso y cuidado (19 pages)

Table Of Contents

Table of Contents

Lift the range hood up under cabinet and determine

final location by centering beneath cabinet. Mark on

the underside of cabinet the location of the 4 keyhole

mounting slots on the range hood (See slot dimensions

on page 6). Set range hood aside on a covered surface.

A. Keyhole slot

Use ¹⁄

" (3 mm) drill bit and drill 4 pilot holes as shown.

NOTE: Make the drill holes on the thin area of the slot.

Install the 4 - .45 cm x 1.3 cm mounting screws in

pilot holes. Leave about ¼" (6.4 mm) space between

screw heads and cabinet to slide range hood into place.

For roof installations, remove the top rectangular or

•

round vent knockout depending on which vent system

you desire to install. For wall installations, remove the

rear rectangular vent knockout.

A. Top rectangular knockout

B. Rear rectangular knockout

C. Top round knockout

A. Drill pilot hole

¹⁄4"

(6.4 mm)

Vent Connector Installation

Install 7" (17.8 cm) round vent mounting plate or 3¼" x

10" (8.3 x 25.4 cm) vent connector, depending on your

vent system installation. Attach to range hood using the

indicated screws provided in hardware kit.

NOTE

The " (1.8 cm) round vent mounting plate or

the 3¼" x 10" (8.3 x 25.4 cm) rectangular vent

connector can be installed up to 1" (. cm) on

either side of the hood center to accommodate

off center ductwork.

If a vent damper is installed with a wall cap with

•

damper, check that they do not interfere with each

other. Remove the vent connector damper flap if

they interfere.

Power Supply Cable Installation

For direct wire installations, run the home power

supply cable according to the National Electric Code

or CSA standards and local codes and ordinances.

There must be enough wiring from the fused disconnect

(or circuit breaker) box to make the connection in the

hood electrical terminal box.