Unset; Fullset - Siemens SPCK 420 User Manual

6.1.1
6.1.2
Siemens AB
Security Products
1

UNSET

Performs an Unset on the system. If multiple areas are defined then each area is
presented in a sub-menu. For a single area system this option is only presented
when the system is Set.
2

FULLSET

Performs a Fullset on the system. If multiple areas are defined then each area is
presented in a sub-menu. For a single area system this option is only presented
when the system is Unset.
3 PARTSET A Performs a Partset A on the system. If multiple areas are defined then each area
is presented in a sub-menu.
4 PARTSET B Performs a Partset B on the system. If multiple areas are defined then each area
is presented in a sub-menu.
UNSET
To UNSET the system:
1. Enter a valid user code.
 The keypad displays a prompt to unset the system.
2. Press SELECT.
 The keypad display indicates that the system is unset on the bottom line of
the display for approximately 5 seconds. After this time has elapsed, the
bottom line is cleared.
3. If the alarm has been activated, enter the user code.
 All bells and strobes are silenced.
 The message PANEL DISARMED displays on the keypad for
approximately 5 seconds.
 The source of the alarm condition displays on the keypad and the Alert
LED flashes.
 The keypad continues to display the alert until the alert is restored.
FULLSET
The FULLSET option provides the following functionality:
Full protection to a building (opening of alarm zones activates alarm)

Opening of entry/exit zones starts the entry timer. If the alarm is not unset

before the entry timer expires, the alarm is activated
To select the FULLSET option:
1. Scroll to FULLSET.
2. Press SELECT.
 The second line displays the exit time and the buzzer sounds to indicate that
the user should exit the building.
 When the system has been fully set, the LCD displays SYSTEM FULLSET on
the bottom line for approximately 10 seconds.
User programming via the keypad
Setting and unsetting the system
6
15
A6V10209178
26.09.2011