Soft-Carrier Dekey Setting; Rx And Tx Time-Out Settings - GE MDS SD Series Reference Manual

44 SD Series Ref. Manual (Packet & Transparent Mode)
1. Select from the menu and enter the receive frequency (in MHz)
RX
in the field to the right of the screen (
to apply the change.
2. Select from the menu and enter the transmit frequency (in MHz)
TX
in the field to the right of the screen (
to apply the change.

Soft-Carrier Dekey Setting

setting is located on the
The Soft Carrier Dekey
(Figure 36). It specifies how long (in ms) to wait after the removal of the
keying signal before actually dropping the transmitter's carrier. The
default setting is , but it may be set to any value up to
0
In most cases, no change is required from the Soft-Carrier Dekey default
setting. A possible exception may be if the transceiver will be
inter-working with certain early-generation MDS radio equipment. If
changes are required, proceed as follows:
1. Select
Soft Carrier Dekey
item clears and presents a flashing cursor.
2. Enter the desired soft-carrier dekey time and Press the
apply the change.
Figure 36. Advanced Settings Menu
(
Radio Configuration>>Advanced Settings

RX and TX Time-Out Settings

RX and TX timeouts may be used to set limits on how long the receiver
and transmitter can operate continuously before shutting down. These
settings are located on the Advanced Settings Menu (Figure 36).
). Press the
xxx.xxx
xxx.xxxxx
Advanced Settings Menu
from the menu. The field to the right of the
Invisible place holder
MDS 05-4846A01, Rev. C
key
ENTER
). Press the key
ENTER
ms.
255
key to
ENTER
)