Removing And Replacing The Popple Dome Pc Board - Motorola V3 Service Manual

Digital wireless telephone

Hide thumbs Also See for V3:

Table of Contents

Disassembly

Removing and Replacing the Popple Dome PC Board

Remove the battery cover and battery, SIM, rear housing, transceiver board

assembly and antenna as described in the procedures.

Turn the Transceiver PC board assembly over and use the disassembly tool to

unseat the popple dome board flex connector (see Figure 12).

Popple dome board

Popple dome flex connector

Figure 12. Removing the Popple dome FLEX Connector

Separate the popple dome board from the transceiver PC board assembly.

To replace, insert the popple dome flex connector squarely into its mating

connector on the transceiver board and press firmly until it snaps into place.

Turn the popple dome board over onto the transceiver PC board.

Insert and tighten the transceiver PC board screw with the T6 driver to a

torque setting of 13 N/cm. Do not overtighten.

Carefully place the transceiver board and the switchdome assembly into the

front housing.

Insert the display flex connector squarely into its mating connector on the

transceiver board and press firmly until it snaps into place.

Replace the rear housing, antenna, SIM, battery, and battery cover as

described in the procedures.

January 31, 2006

Transceiver PC board

Disassembly tool

V3x

051235a

6809497A15-A

Table of Contents

V3x