Motorola V3 Service Manual page 35

Level 1 and 2 Service Manual
6809497A15-A
9. Insert the disassembly tool between the flip assembly and the flip housing to
release the 3 latches on each side of the flip assembly (see Figure 17).
Flip Assembly
Figure 21. Removing the Display Lens
10. Carefully lift the flip cover away from the flip assembly. Avoid damaging the
display flex cable and connector.
11. To replace, align the flip cover with the flip assembly. Press the flip cover onto
the flip assembly until the 6 latches are fully engaged.
12. Insert and tighten the 4 flip screws with the T5 driver to a final torque setting
of 0.6 in.-lbs. Do not overtighten.
13. Remove the adhesive from the back of the new display lens and apply lens to
the flip housing.
14. Replace the flip assembly, keypad assembly, transceiver board assembly, rear
housing, antenna, SIM, battery, and battery cover as described in the
procedures.
January 31, 2006
Flip Housing Catch
Flip Housing Catch
Disassembly
Flip Housing
Catch
040958o
35