Electrolux SBB800S-1 Installation Manual page 34

Connecting Remote Controller Cord to Unit
Tie the redundant cord outside the water heater. Do not put the extra length inside the equipment.
cause problems).
the terminal block.
Remote controller cord
1. Check to make sure that the remote controller
cord has plenty of slack in order to reach the
external connection terminal block.
2. Disconnect electrical power to the water heater.
3. Remove the single screw securing the terminal
block cover and then remove the cover.
4. Pass the remote controller cord through the wiring
of the remote controller cord to the terminal block.
5. Replace the terminal block cover and install the
screw previously removed in step 3.
6. Reconnect electrical power to the water heater.
Changing Other Features
Adjusting the Temperature Display
Table of Setting Items
Item No.
Item
Celsius/Fahrenheit
12
display mode.
Remote Controller
Display
Setting Procedure
1. Turn the water heater off by pressing the Power On/Off Button on the remote controller.
2. Disconnect, then reconnect electrical power to the water heater.
3. Press the Flow Meter Alarm Set Button and hold it in for 2 seconds or more.
4. Press the Flow Meter Alarm Set Button until the remote controller displays item number "12".
5. Press Setting Button " " for 5 seconds or more to change the display units to °F.
6. Press Setting Button "
7. To con rm the setting, turn the water heater on by pressing the Power On/Off Button on the
remote controller.
32
Choices (factory defaults shaded)
°F (Fahrenheit) °C (Celsius)
" for 5 seconds or more to change the display units to °C.
External connection
terminal block
Wiring throughway
Remote controller cord
Setting Button
Power On/Off Button
Flow Meter Alarm Set button