Gearcase Lubrication - Husqvarna HUV 4214 User Manual

Gasoline utility vehicles
Table of Contents

Advertisement

Gearcase Lubrication

GEARCASE LUBRICATION
NOTE: Dispose of used oil according to the environmental laws and regulations for your area.
LUBRICATION LEVEL CHECK – FRONT DIFFERENTIAL AND REAR TRANSAXLE
The front differential is equipped with two oil port plugs (1 and 2) (Figure 22). When the vehicle is on a level surface,
use the level indicator hole (upper plug) (1) as a lubricant level indicator. Lubricant level should be even with the
bottom of level indicator hole (1).
The rear transaxle is equipped with a fill plug/dipstick (1) located on the top of the rear transaxle (Figure 24). When the
vehicle is on a level surface, use the fill plug/dipstick (1) to determine the lubricant level (Figure 25) and (Figure 26).
LUBRICATION CHANGE – FRONT DIFFERENTIAL AND REAR TRANSAXLE
Use the lower plug (2) for drainage (Figure 22) and (Figure 23). Remove both plugs to allow the lubricant to drain
faster. See preceding NOTE.
Metal particles may be discovered in the fluid or on the magnetic drain plug when changing the differential or
transmission fluid. These particles are normal and expected for the first few fluid changes. This is a result of the gears
being "net forged," meaning the gears are forged to a shape very close to the final gear size but the teeth are not finish
machined prior to assembly. The "finish machining" occurs when the gears make contact under load during vehicle
operation. The magnetic drain plug is included in the design to collect the metal particles generated from the gear
break in process. This is an established process and is not detrimental to gear service life.
Front differential:
Clean and install the drain plug (2) and washer before filling the front differential with new lubricant (Figure 22). Tighten
the drain plug to 106 in-lb (12 N·m). Use a funnel when filling the front differential through the lubricant level indicator
hole (1). See Periodic Lubrication Schedule on page 33. Tighten the level indicator plug to 10 ft-lb (14 N·m).
807
Figure 22 Front Differential Lubrication
Page 40
2009 HUV 4214, HUV 4414, andHUV 4414-XP Owner's Manual

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents