Husqvarna HUV 4214 User Manual page 43

Rear transaxle:
Clean and install the drain plug (2) and washer before filling the rear transaxle with new lubricant (Figure 23). Tighten
the drain plug to 8 ft-lb (10.8 N·m). Remove the fill plug/dipstick (2) (Figure 25). Use a funnel and tube to fill the
transaxle through the fill plug/dipstick hole (1) located on the top of the rear transaxle (Figure 24). See Periodic
Lubrication Schedule on page 33. Replace rear transaxle dipstick and tighten to 35 in-lb (4 N·m).
808
Figure 23 Rear Transaxle Drain Plug
820
Figure 25 Rear Transaxle Dipstick
819
1. Full Level 2. Safe Level 3. Low Level
824
2009 HUV 4214, HUV 4414, andHUV 4414-XP Owner's Manual
Figure 24 Rear Transaxle Check/Fill Plug
Figure 26 Rear Transaxle Lubricant Level Check
Gearcase Lubrication
Page 41