Step 1: Insert The Dfe-680Tx - D-Link DFE-680TX User Manual

contact your dealer for an exchange.
Follow these four steps to install the DFE-680TX:

Step 1: Insert the DFE-680TX

Under the PC Card standard and the corresponding Japanese JEIDA standard, PC Cards
may safely be "hot swapped" –– it is not necessary to switch the computer's power off
before installing or removing the DFE-680TX, or any other PC Card.
Find/select an open Type II or Type III PC Card slot on your notebook computer's side or
rear panel. Hold the DFE-680TX with the colorful D -Link splash label upward. Notice
that the splash label features a yellow triangle or "arrow," which points to the front end of
the PC Card. Insert the front end of the PC Card into the CardBus slot, and slide the PC
Card all the way into the slot until it reaches a firm stop.
NOTE: Many notebook PCs feature a stacked pair of PC Card slots, logically (but not
physically) designated as Slot 1 and Slot 2.
It is most usual for the lower one of the two slots in the stack to be designated Slot 1, but
there are exceptions. In the subsequent procedure for DFE-680TX software installation, it
might be useful for you to know whether your DFE-680TX is installed in Slot 1 or Slot 2.
Under Windows 95, you can check by opening the Control Panel / PC Card display.
Under DOS it is also possible to make a software check, but it is more difficult. If it
develops that you need to make a trial-and-error determination or correction, then it is
7