DECT system configuration
DECT system configuration
Subscribing the M155 to a DECT system
When the M155 is not subscribed to a system, the message
Registered
appears on the display screen and the M155 cannot be
used.
Always involve your System Administrator in subscribtion activities.
Before you subscribe to a DECT system, you need the following
information:
PIN code: the PIN code used by your M155. The default value is
1234.
PARK code: Use a PARK code system ID only if more than one
DECT system overlaps in your location.
Authentication code: A code required by the DECT system.
Number: The local phone number assigned to your M155.
Name: The name assigned to your M155.
To subscribe your M155 to a DECT system, perform the following
steps:
24
1. Simultaneously press both keys for a short
time.
2. Repeatedly press the Upper key for a short
time until the display shows:
3. Press the Lower key for a short time.
4. Repeatedly press the Upper key for a short
time until the display shows:
5. Press the Lower key for a short time.
Not
Connectivity
Register