Reassembly - Hitachi P 20DA Technical Data And Service Manual

8-1-4. Removal of the Front Base [3] and the Rear Base [47] (See Fig. 11.)
(a) Turn the Knob Ass'y [7] counterclockwise, then the Front Base [3] can be removed.
(b) Remove the four Tapping Screws D4 x 16 [5] which fix the Rear Base [47] to the Housing [33], then the
Rear Base [47] can be removed.
1
2
3

8-2. Reassembly

Perform reassembly in the reverse order of disassembly procedures, observing the special directions given below.
8-2-1. Reassembly of Wiring Ass'y
(a) Be sure to perform wiring according to the wiring diagram (Fig. 15).
(b) Connect the Internal Wire [39] (red) to the plus terminal of the motor and the Internal Wire [36] (black) to the
minus terminal of the motor with solder. Refer to Fig. 13 for the plus and the minus terminals of the motor.
7
8
33
Fig. 11
--- 12 ---
47
5