How To Install The Optional Accessories; Maintenance And Inspection - Hitachi FS 10SA Instruction Manual And Safety Instructions

HOW TO INSTALL THE OPTIONAL ACCESSORIES

1. Installing the dust cover
Position the dust cover as shown in Fig. 4. Engage the dust cover rear as shown
in Fig. 5 and depress the dust cover front downward.
2. Installing the cleaner
Connect the suction hose to the dust cover hole. (If the suction hose cannot be
connected, attach the supplied adaptor and fix with tape.)

MAINTENANCE AND INSPECTION

WARNING:
1. Inspecting the sanding paper
Since continuous use of worn sanding paper will definitely result in low sand-
ing or polishing efficiency, replace it with new paper as necessary.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that they are properly tight-
ened. Should any of the screws be loose, retighten them immediately.
WARNING:
3. Maintenance of the motor
The motor unit winding is the very "heart" of the power tool. Exercise due care
to ensure the winding does not become damaged and/or wet with oil or water.
Fig. 4
Be sure to switch power OFF and disconnect the plug from the
receptacle during maintenance and inspection.
Using this sander with loosen screws is extremely dangerous.
2
Fig. 5
1
15