In Windows Nt 4.0 - HP D7808A User Manual

9 Enter your area dialing code and country. Also, complete
10 Once completed, click

In Windows NT 4.0

NOTE For Windows NT 4.0, ensure that Plug and Play is disabled in
your PC's BIOS Setup program.
To do this, enter the PC's BIOS Setup program by pressing
during startup and set
PC's BIOS Setup program may differ from this).
1 Once your computer has started, insert the Windows NT
2 Click the
3 Enter "
4 The Modem Board Installation Wizard is launched. This will
5 Once completed, click the
6 In the
7 Click the
8 Enter your area dialing code and country. Also, complete
the necessary information under
, for example, enter "0" in the appropriate field if
location
you need to dial zero to get an outside line.
To verify the modem installation, refer to the instructions
on page 22.
4.0 Drivers disk into the floppy disk drive.
Start
A:\setup.exe
floppy disk drive) and click
guide you through the installation of the HP Fax Modem
drivers.


Settings Control Panel
Control Panel
Dialing Properties
the necessary information under
, for example, enter "0" in the appropriate field if
location
you need to dial zero to get an outside line.
then
OK Close
PnP Operating System
button, then click
" (where
A:
.
OK
Start
.
, double-click the
Installing Your HP Fax Modem
Step 3: Installing the Drivers
How I dial from this
.
to
.
Run
is the letter of your
button then click
Modems
button.
How I dial from this
F2
. (Your
No
icon.
21
English