Power Board; Main Board; Reassembly; Illustrated Parts Breakdown - NEC Versa 2600 Series Service Manual

SOLD BY laptopia2005 DO NOT RESELL!!
4-18 Field Service Guidelines

Power Board

Remove the Power Board as follows.

Main Board

The final disassembly step is to remove five stand offs and four screws and lift the main
board from the chassis case.

Reassembly

Reassembly is the reverse of the disassembly process. When reassembling use only the
proper screws and stand offs in their appropriate locations. Make sure that all connectors
are properly connected and don't over tighten when replacing screws.

ILLUSTRATED PARTS BREAKDOWN

The next section contains the NEC part numbers and illustrated parts breakdown (IPB) fig-
ure for the NEC Versa. Figure 4-14 shows the system exploded view diagram, or IPB. Ta-
ble 4-2 lists field-replaceable parts and corresponding part numbers.
Review the entire exploded diagram to see how each part is connected or assembled. Try to
sub-divide the entire diagram paying particular attention to the LCD Assembly, Top Unit
Cover Assembly, and the Base Unit Assembly.
1. Remove one screw and one stand off.
2. Lift up on the Battery connector. This disconnects the power board from the main
board.
Slide the board towards the front of the laptop to release the power board from
3.
the Main board.
SOLD BY laptopia2005 DO NOT RESELL!!