Table of Contents
Advertisement
66
Ejecting Disk
Follow the procedure below to eject the disk from the Built-in DVD-RAM drive. See
Appendix B for the description on the disk and the notes on handling the disk.
Handle the disk carefully. Handling the disk roughly may cause it to be broken and
•
then a part or all of the data saved in the disk to be lost.
Depending on the usage environment (including the computer, operating system,
•
device driver, and formatting software), a predefined procedure may be required to
eject the disk from the Built-in DVD-RAM drive correctly or the disk may be ejected on
the computer screen without the depression of the eject button.
Be sure to take off the disk before the power of the computer is turned off. Turning off
•
the power of the computer with the disk remaining inserted may cause the disk and/or
Built-in DVD-RAM drive to be damaged.
Do not push the eject button while the busy indicator is illuminating. If the eject button
•
is pressed while the busy indicator is illuminating, the disk will be ejected only after
the busy indicator goes off.
1.
Make sure that the power of the computer is on.
2.
Make sure that the busy indicator is off.
3.
Press the eject button.
The tray is ejected.
4.
Hold the end of the disk and take off it straight from the Built-in DVD-RAM drive
slowly and carefully.
Put the disk into the exclusive case and save it carefully.
5.
Press the eject button to close the tray.
Advertisement
Table of Contents
