Others - Panasonic Diga DMR-PWT500 Operating Instructions Manual

Home Network ( DLNA ) Server Settings
You can set the DLNA (Server) function (
Network Settings
Home Network ( DLNA ) Server Settings
Home Network ( DLNA ) Server Settings
Home Network ( DLNA ) Server function
Setting device name
Registration type for remote devices
Remote device list
Home Network ( DLNA ) Server
function
You can switch between enable/disable of the DLNA
(Server) function.
≥If "On" is selected, "Power Save in Standby" is
fixed to "Off". ( right)
Setting device name
It is also possible to change the name of this unit on
the network.
≥Select from a preset list
Select the preset name, then press [OK].
≥Create name
Enter the name. ( 66, Entering text)
Registration type for remote devices
Automatic All connected devices on the same
network can access this unit.
Manual Only registered devices can
access this unit.
Remote device list
≥This function cannot be enabled when "Manual" is
selected in "Registration type for remote devices".
( above)
≥To register equipment manually
1 Select the device name or the MAC Address for
the device you want to register, then press
[OK].
2 Select "Yes", then press [OK].
≥To deregister equipment
1 Select the registered equipment, then press
[OK].
2 Select "Yes", then press [OK].
≥ The maximum number of equipment that can be registered is
16.

Others

70)
Others
Setup
Others
∫ Standby Settings
Others
Standby Settings
Power Save in Standby
On
On Timer
Off
≥This function cannot be enabled when the DLNA
function is enabled in "Home Network ( DLNA )
Server Settings". (
≥The setting may be changed to "Off" automatically
when the setting for video communication is changed.
( 67)
Automatic Standby
Set the time to turn the unit to standby mode
automatically.
After the unit has finished operating, the unit will be
turned to standby mode once the set time has passed.
≥When "REWIND LIVE TV" is set to "On"(
cannot be selected.
Standby Settings
Remote Control
Clock
PIN Entry
System Update
System Information
DivX Registration
Initialize
Enlgish
Standby Settings
Power Save in Standby
Automatic Standby
Automatic Standby after OTR
Automatic Standby after Copy
RF OUT ( Aerial Signal )
It will go into the "Power Save in
Standby" mode.
"Power Save in Standby" is activated
when the set time comes.
≥If the clock has not been set, "Power
Save in Standby" is activated at all
hours.
It is possible to start quickly from the
standby mode. (Quick Start mode)
left)
Enlgish
Enlgish
77), "Off"
83
VQT3C84