Panasonic Diga DMR-PWT500 Operating Instructions Manual page 84

Changing the unit's settings
Automatic Standby after OTR
If "On" is selected, this unit is turned to standby mode
when it is not operated for approximately 5 minutes
after completing "Automatic Stop" or "Recording Time"
( 28).
Automatic Standby after Copy
If "On" is selected, this unit is turned to standby mode
when it is not operated for approximately 5 minutes
after completing copy (
RF OUT ( Aerial Signal )
Set whether to output the aerial signal or not from RF
OUT while in standby mode (when "Power Save in
Standby" is activated).
≥If "On" is selected, the aerial signal is output from this
unit.
∫ Remote Control
Change the remote control code on the main unit and the
remote control if you place other Panasonic products close
together.
≥Use "BD 1", the factory set code, under normal
circumstances.
1 Select the code, then press [OK].
2 While pressing [OK], press and hold the number button
([1] to [6]) for more than 5 seconds.
3 Press and hold [OK] for more than 5 seconds.
4 Press [OK].
≥Operation is possible only with Panasonic remote controls
with "IR6" printed at the bottom when the remote control
code of this unit is set to "BD 4", "BD 5" or "BD 6".
BLU-RAY DISC PLAYER/HDD RECORDER
BLU-RAY DISC PLAYER/HDD RECORDER
IR6
84
VQT3C84
50).
IR6
IR6
∫ Clock
If the time is not set correctly, use the settings listed in the
method below.
Clock
Automatic Region Selection Daylight Saving Time
On
NSW / ACT Automatic
Time Date
12 00 10 AM 1 1 2011
Please set the clock.
OK: access RETURN: leave
OK
RETURN
≥Automatic
This unit usually obtains time and date information from
digital broadcasts.
But, if the time is not set correctly, set it to "Off" and
perform "Manual setting".
≥Region Selection
Select the region where you live to adjust the standard
time.
≥The time contained in the broadcast signal is UTC
(Universal time, coordinated).
≥Daylight Saving Time
Select time offset from the standard time for Summer
Time.
≥If there is a gap between displayed time and actual time,
set this function.
≥Manual setting
1 Select "Off" of "Automatic", then press [OK].
2 Select the item you want to change.
3 Change the setting.
4 Press [OK] when you have finished the settings.
∫ PIN Entry
You can set/change the PIN. ( 74)