Operation - Hitachi BD-W3300 Instruction Manual

In case of when abnormal situations happen
Symptoms
The spinning is
insufficient
The laundry such
as socks and
handkerchiefs is
jammed between the
door inside and the
door bellows during

operation

After the operation
finishes, there are
water drops on the
inside and underside
of the door and the
door bellows.
The laundry stick
on the inside of the
tumbling drum after
the operation fi nishes
Power supply turns
off if the operation
is paused during
spinning
Water is used during
drying operation
90
Please check the following items
Is the time set for spinning short?
Is the washing load too much?
They are caused by the water drops splashed during washing
or spinning or the water drops.
Have you put in a lot of cotton laundry?
The unwinding operation is performed after the rinsing
process in the [FUZZY] program. However, cotton laundry
may not be unwound fully.
Have you performed the [WASH > DRY] operation for a small
washing load?
Because the drying operation is performed with the laundry
sticking on the tumbling drum, add the washing load.
Has the [UNWINDING SPINNING] setting been cancelled?
If the washing load still sticks to the drum
Did you run the [UNWINDING SPINNING]?
Are you running the [STATIC DRY] or Night program?
Have you set water-cooling dehumidification method?
Water may be used depending on the surrounding
environment or piping condition.
Adjustment method
Set longer time for spinning. (P.55)
When there is a lot of laundry, put small articles such as socks
and handkerchiefs in the commercially available "cleaning net" in
washing or it is recommended to use the washing cap.
Put small laundry into the inside of the drum and then other
articles to be washed and run.
Use the Washing Cap available separately.
Wipe them off with a dry cloth is required.
Run the Soft program.
Set the [UNWINDING SPINNING] if it has got cancelled.
Add the washing load.
For setting and canceling the [UNWINDING SPINNING]
It is recommended to use a softener.
It is not an error.
When the operation is paused during unwinding spinning, power
supply is turned off to complete the unwinding spinning.
It is not an error.
It is not an error.
For air-cooling / water-cooling dehumidification method, refer to
It is not an error.
(Continued)
(P.100)
(P.70)