Sony XDR-F1HD Service Manual page 5

Connecting the system
component before making the connections.
L
ANTENNA
AM FM
RESET
R
AUDIO OUT
AUDIO OUT AUDIO OUT
(Stereo pin plug) (Stereo pin plug)
(Red) (R) (White) (L)
Audio cable (Not supplied)
Audio input Audio input
(White) (L) (Red) (R)
Notes
• Install this system so that the power cord can be
unplugged from the wall socket immediately in the
event of trouble.
• If noise occurs, separate the unit from other
components.
• Noise may occur during AM reception if the unit
Connecting the antenna
To connect the AM loop
antenna
to receive AM signals. Do not dismantle or roll up the
antenna.
1
Remove only the loop part from the plastic
stand.
2
Set up the AM loop antenna.
3
Connect the cords to the AM antenna
terminals.
Cord (A) or cord (B) can be connected to either
terminal.
Insert the cord while
pushing down the
terminal clamp.
Only insert up
to here.
A B
4
Make sure the AM loop antenna is connected
Adjusting the AM loop antenna
Find a place and an orientation that provide good
reception.
• Do not place the AM loop antenna near the unit or
other AV equipment, as noise may result.
Tip
Adjust the direction of the AM loop antenna for best AM
broadcast sound.
To connect the FM antenna
Connect an antenna that provides good reception to the
FM antenna terminal.
FM dipole antenna
(supplied)
Adjusting the FM dipole antenna
Be sure to fully extend the FM dipole antenna. Attach the
antenna in the shape of a T to a high position on a wall
away from this unit.
Tip
If you have poor FM reception, use a 75 Ω coaxial cable
(not supplied) to connect the unit to an outdoor FM
antenna as shown below.
ANTENNA
AM FM
Outdoor FM antenna
XDR-F1HD
5