Preparation
IP Network Settings
To properly connect the unit to an IP network, the
following settings must be set to match the settings of
the IP network. Consult your system administrator for
the appropriate settings.
–
IP address mode: Automatic (DHCP) or manual
(static) IP address assignment (default: static)
–
IP address (when static connection mode is
selected; default: 192.168.0.2)
–
Subnet mask (when static connection mode is
selected; default: 255.255.255.0)
–
Default gateway (when static connection mode is
selected; default: 0.0.0.0)
Note
•
IP addresses can be entered using the keypad.
[0]–[9] are used to enter numbers and [ ] is
used to enter a period. For example, to enter
"192.168.0.1", press [192 168 0 1].
Automatic Assignment (DHCP)
1.
Press [MENU].
2.
Select "IP Network Settings", then press
.
SELECT
3.
Select "IP Address Mode", then press
4.
Select "DHCP", then press
5.
Press [MENU].
Note
•
If this setting is changed, the unit must be
restarted before the new setting becomes
effective (see page 47).
•
To confirm the IP address, press
[MENU]®"Show IP Address"®
26
Operating Instructions
.
SELECT
.
SAVE
.
SELECT
Manual Assignment (Static)
1.
Press [MENU].
2.
Select "IP Network Settings", then press
.
SELECT
3.
Select "IP Address Mode", then press
4.
Select "Static", then press
5.
Select "IP Address", then press
6.
Enter the IP address to be assigned to the unit, then
press
.
SAVE
7.
Select "Subnet Mask", then press
8.
Enter the subnet mask, then press
9.
Select "Default Gateway", then press
10.
Enter the IP address of the default gateway, then
press
.
SAVE
11.
Press [MENU].
Note
•
If this setting is changed, the unit must be
restarted before the new setting becomes
effective (see page 47).
•
To confirm the IP address, press
[MENU]®"Show IP Address"®
.
SELECT
.
SAVE
.
SELECT
.
SELECT
.
SAVE
.
SELECT
.
SELECT
Document Version
2010/02