Motorola Netopia 2200 Series User Manual page 215

CONFIG Commands
IP Settings
You can use the command line interface to specify whether TCP/IP is enabled, identify a
default Gateway, and to enter TCP/IP settings for the Motorola Netopia® Gateway LAN and
WAN ports.
☛
NOTE:
For the DSL platform you must identify the virtual PPP interface [vccn], a num-
ber from 1 to 8.
Common Settings
set ip option { on | off }
Enables or disables TCP/IP services in the Motorola Netopia® Gateway. You must enable
TCP/IP services before you can enter other TCP/IP settings for the Motorola Netopia®
Gateway. If you turn off TCP/IP services and save the new configuration, the Motorola
Netopia® Gateway clears its TCP/IP settings.
ARP Timeout Settings
set ip arp-timeout [ 60 ... 6000 ]
Sets the timeout value for ARP timeout. Default = 600 secs (10 mins); range = 60 secs -
6000 secs (1–100 mins).
DSL Settings
set ip dsl vccn address ip_address
Assigns an IP address to the virtual circuit. Enter 0.0.0.0 if you want the virtual circuit to
obtain its IP address from a remote DHCP server.
215