Safety Instructions; Before Operating; While Operating - Toro ProCore Processor Service Manual

Safety Instructions

The ProCore Processor is designed and tested to offer
safe service when operated and maintained properly.
Although hazard control and accident prevention par-
tially are dependent upon the design and configuration
of the machine, these factors are also dependent upon
the awareness, concern and proper training of the per-
sonnel involved in the operation, transport, mainte-
nance and storage of the machine. Improper use or
maintenance of the machine can result in injury or
death. To reduce the potential for injury or death, comply
with the following safety instructions.

Before Operating

1. Read and understand the contents of the Operator's
Manual and Operator Training DVD before starting and
operating the machine. Become familiar with the con-
trols and know how to stop the machine quickly. A re-
placement Operator's Manual is available on the
Internet at www.Toro.com or by sending the complete
model and serial number to:
The Toro Company
Attn. Technical Publications
8111 Lyndale Avenue South
Bloomington, Minnesota 55420--1196

While Operating

1. Operator should be in the tow vehicle operators posi-
tion when operating the ProCore Processor. Stay away
from the Processor when it is operating.
2. Do not run ProCore Processor engine in a confined
area without adequate ventilation. Exhaust fumes are
hazardous and could possibly be deadly.
3. Do not touch engine, muffler or exhaust pipe while
the engine is running or soon after it is stopped. These
areas could be hot enough to cause burns.
4. If abnormal vibration is detected, stop tow vehicle
and ProCore Processor immediately and determine
source of vibration. Correct problems before resuming
the use of the Processor.
Safety
To reduce the potential for injury or death,
comply with the following safety instructions.
2. Keep all shields, safety devices and decals in place.
If a shield, safety device or decal is defective, illegible
or damaged, repair or replace it before operating the
machine. Also tighten any loose nuts, bolts or screws to
ensure machine is in safe operating condition.
3. Make sure that the tow vehicle is carefully selected
to assure the best performance and safe operation of
the ProCore Processor.
4. Make sure that the operator is familiar with tow ve-
hicle operation.
5. Make sure that the ProCore Processor is properly at-
tached to tow vehicle before operating.
5. During operation of the ProCore Processor, noise
levels may exceed 85dB(A) at the operator position.
Hearing protection is recommended for prolonged ex-
posure to reduce the potential of permanent hearing
damage.
6. Before leaving the operator's position of the tow ve-
hicle:
A. Park on level surface and stop ProCore Proces-
sor engine. Make sure that all machine motion has
stopped.
B. Ensure that tow vehicle traction lever or transmis-
sion is in neutral, set parking brake, stop engine and
remove key from ignition switch.
Page 1 - - 2
WARNING
ProCore Processor