Toro ProCore Processor Service Manual page 76

Solenoid Valve Coil (Tow Hitch Kit)
Removal (Fig. 17)
1. Make sure that Processor ignition switch is in the
OFF position. Remove key from the ignition switch.
2. Disconnect wire harness electrical connector from
the solenoid valve coil that is to be removed.
3. Remove nut that secures solenoid coil to solenoid
valve.
4. Slide solenoid coil from valve.
Installation (Fig. 17)
1. Clean valve stem and solenoid coil bore.
2. Slide coil onto solenoid valve.
3. Secure coil with nut. Torque nut 60 in- -lb (6.8 N- -m).
4. Connect wire harness electrical connector to the so-
lenoid valve coil.
Electrical System
3
4
60 in- -lb
(6.8 N- -m)
6
1. Solenoid coil S1
2. Solenoid coil S2
3. Solenoid coil S3
4. Solenoid coil S4
Page 5 - - 16
7
6
7
Figure 17
5. Offset manifold
6. Nut
7. Nut
ProCore Processor
60 in- -lb
(6.8 N- -m)
1
UP
5
2