SW-D7000U, 9CH. COLOR VIDEO MULTIPLEXER
Pin
1
2
3
4 (NC)
5 (NC)
6
7
8
For networks longer than 30 feet, you must terminate the network at each end for it to work reliably.
The network is polarity dependent, so you must connect pin 3 to pin 3 and pin 4 to pin 4. Do not
reverse the polarity of the network.
Do NOT use the DC 12V power leads in the RS-485 cable UNLESS it is to be used on a one-to-one
connection between a unit with DC 12V power and a unit with no DC 12V power. For example, from a
multiplexer directly to a keyboard that does not have its own power source. In all other
circumstances, such as multi-dropped multiplexers, do NOT use the DC 12V power leads in the RS-
485 cable.
If you choose to power another unit (e.g. a single keyboard), you can do this up to 30 feet from the
multiplexer. Use a 4-core shielded cable, equivalent to Belden 8723.
For more detail on the remote keyboard, refer to the JVC-KB Remote Keyboard instruction sheet.
4.16 FRONT PANEL LOCK
This option is used to lock and unlock the front panel keyboard of the multiplexer. You get the
following menu:
Once LOCK KEYBOARD is selected, the multiplexer can only be operated again through the input of
the proper password. The only key which will operate is the MENU key.
4.17 FACTORY SETTINGS
This option is used to reset the multiplexer to factory settings. The password for this setting is only
available for factory authorized service personnel. Contact Customer Support for further information.
4.18 PASSWORDS
This option is used to change the passwords for the menu system. You get the following menu:
JVC PROFESSIONAL, IMAGING PRODUCTS
Use
GND
DC +12V
Network +ve
-
-
Network -ve
GND
DC +12V
Unlock Keyboard
Lock Keyboard
Installer Password
Operator Password
77