Hitachi CJ 14DL Technical Data And Service Manual page 20

3. Disassembly of the housing
(1) Remove the Guard Bar [8].
(2) Loosen the eight Tapping Screws (W/Flange) D4 x 20 (Black) [6] and open the housing.
(3) Remove the Plate Spring [28] from the housing.
(4) Loosen the Tapping Screw (W/Sp. Washer) D3 x 8 [10] and remove the Fence [9] from the housing.
(5) The other housing can then be removed from the main body. After disassembly, remove the two
O-rings (P-6) [5] from both sides of the housing.
Disassembly of the housing
Guard Bar [8]
4. Removal of the plunger and the blade holder
(1) Pull out the Pin D6 [27] from the Gear Holder [38], and remove the Plunger [30] and Plunger Holder (A)
[29].
(2) Loosen the Seal Lock Hex. Socket Hd. Bolt M3 x 6 [25] and the Seal Lock Hex. Socket Hd. Bolt M3 x 8
[24], and remove the Blade Holder [26].
(3) Pull out the Packing Cover [41], Packing [42] and Plunger Holder (B) [40] from the Plunger [30].
Removal of the plunger and the blade holder
Plunger Holder (A) [29]
Seal Lock Hex. Socket Hd. Bolt
M3 x 6 [25]
Seal Lock Hex. Socket Hd. Bolt
M3 x 8 [24]
Housing (A).(B) set [1]
Tapping Screw (W/Sp. Washer) D3 x 8 [10]
Fence [9]
Pin D6 [27]
Blade Holder [26]
Packing Cover [41]
O-ring (P-6) [5]
Plate Spring [28]
Plunger [30]
Plunger Holder (B) [40]
Packing [42]
-17-
Tapping Screw (W/Flange)
D4 x 20 (Black) [6]
Gear Holder [38]