Hitachi CJ 14DL Technical Data And Service Manual page 23

Reassembly can be accomplished by following the disassembly procedures in reverse. However, special
attention should be given to the following items.
1. Mounting the change knob
Mount Spring (C) [49] and the Steel Ball D3.97 [50] into the Change Knob [48] as shown in the figure
below.
Mounting the change knob
Steel Ball D3.97 [50]
Retaining Ring (E-Type)
for D5 Shaft [39]
2. Mounting the gear holder
Before mounting the Roller Holder [44], be sure to insert the Needle Roller [43] into the designated position
of the Gear Holder [38] because the Needle Roller [43] cannot be inserted after mounting the Roller Holder
[44].
Mounting the gear holder
Gear Holder [38]
Reassembly
Spring (C) [49]
Change Knob [48]
Needle Roller [43]
Roller Holder [44]
-20-