Hitachi CJ 14DL Technical Data And Service Manual page 22

7. Removal of the roller holder
(1) Remove the two Retaining Rings (E-Type) for D3 Shaft [55] from the Pin [45].
(2) Pull out the Needle Roller [43] press-fitted in the Gear Holder [38] and remove the Roller Holder [44].
(3) Remove the Needle Roller [43] remained in the Gear Holder [38].
Removal of the roller holder
Retaining Ring (E-Type) for D3 Shaft [55]
8. Removal of the change knob
(1) Remove the Retaining Ring (E-Type) for D5 Shaft [39], and remove the Change Knob [48],
Spring (C) [49] and Steel Ball D3.97 [50].
(2) Be careful not to lose Spring (C) [49] and the Steel Ball D3.97 [50].
Removal of the change knob
Change Knob [48]
Needle Roller [43]
Roller Holder [44]
Pin [45]
Steel Ball D3.97 [50]
Spring (C) [49]
Retaining Ring (E-Type)
for D5 Shaft [39]
-19-
Gear Holder [38]