Table of Contents
Advertisement
Menu system
>>> Motion Setup
• To restore the default motion settings select the
item.
Settings
• Select the
Display Monitor
cameras to be activated on the monitor for each motion event. The
submenu sets the area and sensitivity for each camera.
Motion Area
• Select the number of the output relay that is activated when motion
is detected.
• Enable the beeper to activate it when any motion is detected.
Display mon A
• Select the camera number that generates the motion event.
• If you have controllable cameras, set a camera number and a pre-
position number (1 to 99). The specified camera goes to this
position when motion is detected by the selected camera (not
necessarily the controllable camera).
• Select a view mode. Only view modes that are enabled can be
selected.
• If you have selected the full-screen or quad view mode, select the
cameras to be displayed.
Display mon B
• Select the camera number that generates the motion event.
• If you have controllable cameras, set a camera number and a pre-
position number (1 to 99). The specified camera goes to this
position when motion is detected by the selected camera (not
necessarily the controllable camera).
• Select up to four cameras to be displayed in sequence.
5-10
Clear Motion
submenu to set up the view mode and
Motion area
• Select a camera number.
• The
motion indicator
that has been detected for the defined area. Press F2 to clear it if you
want to re-test the level of motion detection.
• Use the arrow keys to adjust the
the indicated motion level.
• A motion detection signal is generated when the level of motion
reaches the trigger level set.
Edit area
• Select
to define the picture area where motion is
Motion Area
detected.
• Use the arrow keys to move around the grid. Press F1 to insert a
motion detection area and use the arrow keys to enlarge it. Press F1
again to save the area. Press the escape key to cancel and return to
grid square selection.
• Press the select key to leave the grid. F2 clears all motion detection
areas.
>>> Video loss Setup
• Select the monitor on which the camera with the video loss is
displayed.
• Select the number of the output relay that is activated when video
loss occurs.
• Enable the beeper to activate it when any video loss occurs.
>> History Log Setup
• Select
for those events that you want to log in the history file.
Yes
• The entire history list is erased if you select the
• Date/time changes of stored video are always logged and cannot be
disabled or cleared.
shows the maximum level of camera motion
slider to just below
Trigger level
item.
Clear History
Philips Communication, Security & Imaging
Advertisement
Table of Contents
