Table of Contents
Advertisement
Error Code
#20
Error Code
#21
Error Code
#22
Error Code
#23
9030/40 Diagnostics
5-3
BAD RTC: NNNNN
BAD RTC: SELECT CODE NN
- Indicates that the built in Real Time Clock is not operating correctly.
BAD SP: SELECT CODE NN -
Indicates that the HP 9030 and HP 9040 computer's
service processor failed self-test.
T
est car
d f
0
un d -
(Not an error.)
Test Module did not find SCM
HP-UX 4.0 Operating System Error Messages
Warning and Error Messages
C 1
0 C
K and d ate not set, -
This message indicates that either the contents of the NVM are not
valid at powerup or the clock has not been set since this condition was detected. Possible causes: a
bad battery on the SCM board, or computer powered down for more than 2 weeks. The condition
does not stop the system operation.
Self test error 1:
liD
address AA, SS STATUS: XXXXXXXX
Where:
AA
=
Select code
SS
=
Subaddress
XXXXXXXX
=
Device or card dependent error information (in hexadecimal).
This error message is displayed as a result of the self-test failure of an
110 device. The select code
sub address denote the device, and the device dependent error information indicates the nature of
the failure. System operation can continue provided that use of the failed device is not required.
Se 1 f t est e r ro r 2: CHECKSUM for s e
~Men
t NN -
When the system is powered up, or a system
reset is executed, the checksum for every code segment of the operating system is computed and
compared to a checksum in the operating system code. When the checksums do not agree for a
segment, the segment number is stored. As a result, the segment reported is the last segment for
which a checksum error was detected. The operation of the system is not halted, however, further
operation is at your own risk.
Self test error 3: XXX X NN
Where:
XXXX
=
"CPU#", "IOP#", or "MC#_".
NN
=
The Nth of that type of component (counting from the bottom of the stack).
This error occurs when the system is able to get completely through the board self-test and the
loader self-test, but a failed stack component is detected by the operating system. The message
indicates the type of component which has failed and its relative position in the stack. Operation of
the system can continue, if the failed board is not required,
Advertisement
Table of Contents
