Reversing The Door (Affinity); Removing The Door - Frigidaire Dryer Servicing

Section 2 Installation Information
Reversing the Door

Removing the door

1. Protect flat work surface, such as top of dryer or
floor near dryer, with a soft cloth or towel.
2. Open dryer door and remove the two hinge screws.
Remove lower screw first, then upper screw.
(See Figure 2-17)
3. Supporting door with both hands, squarely lift door
and hinge upward approximately 3/8" (10 mm) so
"T" post on back of hinge can slide out through "T"
slot on front panel. (See Figure 2-18)
4. Gently place dryer door face down on flat, covered
work surface.
5. Locate the 5 indented head screws (no. 1-5) in the
small, circular recesses (at 11, 1, 4, 6, and 8 o'clock
positions) of the inner door. Remove and save these
5 screws. (See Figure 2-19)
IMPORTANT
Do not attempt to remove the 2 "tamper resistant"
screws that hold the inner glass in place.
6. Locate the 2 pan head screws (no. 6-7) on the inner
door nearest the metal strike and center of hinge
(9 and 3 o'clock positions). Remove and save these
2 screws. (See Figure 2-19)
7. Separate inner door assembly from outer door
assembly.
2-14
Screws
Figure 2-17.
"T" Slot In
Front Panel
"T" Post On
Door Hinge
Figure 2-18.
Figure 2-19.