Frigidaire Dryer Servicing page 30

Section 2 Installation Information
Pedestal Installation
5. Set the dryer down onto the pedestal making sure
the dryer base is behind the front brackets of the
pedestal.
6. Align the sides of the dryer with the sides of the
pedestal and attach the dryer to the rear brackets
using four #10 screws (2 per bracket) as shown in
Figure 2-36.
7. With pedestal drawer open for better access, install
the two #10 screws through the front brackets in
the pedestal into the dryer base as shown in Figure
2-37.
8. After closing the pedestal drawer, carefully move the
dryer/pedestal assembly into position.
NOTE
Because of the increased weight caused by the addition
of the pedestal, two or more people may be required.
9. Excessive noise and vibration can be prevented by
properly leveling the dryer/pedestal assembly on a
SOLID floor and tightening the leveling leg lock nuts.
With dryer/pedestal assembly in its final position,
place a level on top of dryer. Adjust pedestal
leveling legs so the dryer/pedestal assembly is level
front-to-rear and side-to side, and stable corner-to-
corner.
Press down on alternate corners and sides and feel
for the slightest movement. Adjust the appropriate
leg so the dryer/pedestal assembly is SOLID on the
floor on ALL four pedestal legs. After leveling the
dryer/pedestal assembly, adjust the lock nut on each
pedestal leveling leg against the pedestal base and
tighten with a wrench. Keep the leg extension at a
minimum to prevent excessive vibration.
10. Complete the installation following the procedures at
the beginning of this section.
2-20
Install Screws
Figure 2-36.
Install Screw
Figure 2-37.